Joist Roof Fill
Fill Plane
Fill Plane after selecting plane as reference point and start joist spacing, clicking on the fill plane button and then selecting a plane to fill. The joist will be laid out either above or below the roof plane pulling spacing from the start joist run point.
Clear
Clears the specific plane of joist members.
Run Line
Allows a user to use a run line (just as in isPlanĀ® joist fill) to specify boundaries to input joist members
Run Line Clear
Allows a user to use a run line to clear a specific area of joist, a few joist, or a single joist.
Pick Ref Point
A user must pick a reference point to define a plane that is going to have joist members drawn. Typically the overhang of the plane is defined as the reference point.
Vertical Alignment
Below Roof Plane
Allows a user to apply roof members below a roof plane. Typically this roof plane has a specified heel height that is above the wall.
Above Roof Plane
Allows a user to apply roof members above a roof plane. Typically this roof plane is sitting on top of the wall and the framing members are applied above it.
Spacing
Allows user to define spacing for members applied to the roof plane.
Perp to Slope
When selected this function will frame roof members perpendicular to slope.
Depending on pitch of roof system certain areas and code bodies may not allow this framing practice.
Ply Count
Play count allows for multiple plies of joist, beams, and other roof framing members.
Filter
Describes the type of framing member being used on a specific plane.
Material
Describes the type of material for that specific plane.
Size
Describes the width and depth or material for that specific plane.
Finished
Finishes the roof joist fill sequence.